Hid high beams not working

12.08.2018 | by Florance
This is the most common cause of a single high beam headlight not working, but isnt common if both high beams arent working, because its highly unlikely that both bulbs would blow at the same time. Only one side is working on my HID kit or LED kit. I would suspect that to be defective or the MFS.

Did your high beams work with the original setup.

It's a source file for the YP map timezone. I wired the low beams and the high beams exactly the same. A blown high beam headlight bulb, an easy fix. Yeah, the high beams work just fine with the standard bulbs. You may need several tries to find the proper orientation.
Hid high beams not working
You probably have a DRL module that is failing or your multifunction switch MFS is stuck on high beam. In the case of high-intensity discharge HID headlights, or Xenon headlights, theres an additional component. Ok i have searched my butt off and could not find anything like this so please help. The daytime running light module controls your headlights. If one side sometimes doesn't turn on it could be caused by a bad bu. Finally, practice using a digital multimeter so you can rule out electrical problems before replacing other components.